Clutch Master Cylinder Adapter for 350Z & G35

$45.00

2 in stock

SKU: RRCL030007 Category:

Description

This bracket will adapt Wilwood, Tilton, or similar small bore master cylinders to bolt directly in place of the factory cylinder on Nissan 350Z and Infiniti G35. The bracket is machined from 6061-T6 aluminum and includes a steel pedal fork. All necessary hardware to bolt the master cylinder to the bracket is included. Great for V8 swaps or large clutches requiring a different bore master cylinder. Fits the following vehicles:
  • 2003-2006 Nissan 350Z
  • 2003-2007 Infiniti G35 coupes
  • 2003-2006 Infiniti G35 sedan
Parts included with kit:
  • Aluminum adapter bracket (1 ea.)
  • Steel pedal fork (1 ea.)
  • Low profile socket head, M8x1.25, 30mm long (2 ea.)
  • Hex head cap screw, M8x1.25, 40mm long (2 ea.)
  • Washer (2 ea.)
  • Nut, nylon locking, M8x1.25 (2 ea.)
  • Low profile socket head, M8x1.25, 25mm long (1 ea.)
RRCL030007 Assembly Instructions (PDF) (master cylinder shown in picture not included)

Additional information

Weight 6 oz
Dimensions 3 × 3 × 2 in

© Rigid Racing, LLC
Oklahoma City, Oklahoma
Contact: Jeremiah Jordan

Disclaimer: The buyer/reader assumes all risk of products listed and modifications documented on this site, and agrees to hold the seller/author harmless for any injury, loss or damage. It is suggested that state and federal regulations be checked. Should any product prove defective after purchase, the seller liability shall be limited to refunding the original cost of the product.